Mold Remediation in Fort Myers, FL That Ends With a Dry House

Where It Hides in Gulf Coast Homes

In this climate, the usual culprits are slow and quiet:

• an air handler closet where the condensate pan overflows or the drain line clogs
• the back of a vanity or kitchen sink cabinet with a weeping supply line
• drywall behind a shower with failed grout or caulk
• a ceiling under a roof spot that started leaking during the last storm
• baseboards and lower walls that were never fully dried after surge or flood water

After Hurricane Ian, plenty of homes were dried quickly but not completely, and growth appeared months later inside wall cavities.

Small Patch or Real Project?

The EPA suggests that an area under roughly 10 square feet, about a three-by-three patch, is often a do-it-yourself job if the cause is fixed. Beyond that, or where there was extensive water damage, it recommends following its professional remediation guidance. We'll tell you honestly which side of that line you're on.

Our Process

1. Find the moisture. Meters and thermal imaging locate the wet materials and the source.
2. Contain the area. Plastic sheeting and negative air keep spores from spreading to clean rooms.
3. Remove what's growing. Porous materials with growth, like drywall and insulation, are cut out and bagged.
4. Clean and treat. Framing and hard surfaces are cleaned and HEPA-vacuumed.
5. Dry and confirm. Dehumidifiers run until readings show the structure is dry.
6. Rebuild. New drywall, paint and trim go back after the cause is repaired.

Keeping a Fort Myers House Mold-Free

The EPA recommends keeping indoor relative humidity below 60 percent, ideally between 30 and 50. In a Gulf Coast summer, that means running the AC, venting bath fans outside and keeping condensate lines clear. A cheap hygrometer tells you how you're doing.

If the mold followed a recent leak and there's still standing water, start with water removal. To see how we handle every other kind of job, visit our Fort Myers restoration crew.